Network Gear

Checks the OSPF Area status and number of re-calculations using SNMP. Will report warning if there is a change in re-calculation in last 24 hours.…

Basic Cisco OSPF check using SNMP. For now only check Admin status of OSPF. Also reports RouterID and OSPF version ./check_snmp_cisco_ospf-general.pl -H 192.168.1.1 -C public…

Based on the work of Yoann LAMY and adapted to meet the requirements of a Lancom Router. Usage: ./check_snmp_router_temperature.sh -H 192.168.0.1 -C public -w 60…

Based on the work of Yoann LAMY and adapted to meet the requirements of a Lancom Router. Usage: ./check_snmp_router_memory.sh -H 192.168.0.1 -C public -w 80…

Based on the script of Yoann LAMY and adapted to meet the requirements of a Lancom Router. Usage: ./check_snmp_router_cpu.sh -H 192.168.0.1 -C public -w 80…

Check if there are any crashinfo files detected on a Cisco device, which would indicate a hard or software issue. You can trigger an alarm…

The Check Cisco ASA Connections plugin monitors the number of open connections through your firewall and returns a warning or critical state depending on the…

Check Admin Up Oper down uses SNMP to find interfaces which are enabled (no shutdown), but are still operationally down. It then reports an issue…

I make some changes in http://exchange.nagios.org/directory/Plugins/Hardware/Network-Gear/Riverbed/Steelhead-Riverbed-status-2Fpeer-check-plugin/details Added support SNMP v3, system CPU, Temp, Uptime, Connections_Count cheks The usage is following: ./qt_check_riverbed_status_v3.pl -H HOST -V 3…