check_interfaces_wmi

This is to bypass the limitations of the 32-bit SNMP v2 counters used by Windows. It produces valid perfdata for input(RX) & output(TX) and can provide either raw data outputs or percentage based. This plugin has a prerequisite of the check_nt plugin being present and a suitable agent on the servers being monitored. Options: -h, --help show this help message and exit -H HOST, --host=HOST Hostname/FQDN or IP address -p PORT, --port=PORT Port that nc_net or nsclient++ is running on (1248) -w WARNING, --warning=WARNING Warning Threshold (percentage of interface speed default to 70 see also -r/--raw) -c CRITICAL, --critical=CRITICAL Critical Threshold (percentage of interface speed default to 90 see also -r/--raw) -S, --special Include special interfaces Teredo IPv6 tunnel and isatap -D, --disconnected Include disconnected interfaces (interface speed = 0) -P PREFIX, --prefix=PREFIX Prefix to Be used Kilo/K, Mega/M, Giga/G, if none specified bits/bytes will be used -r, --raw Use raw values for Warning and Critical thresholds (affected by prefix used i.e. -r -w 1000 -c 2000 -P kilo will set Warning threshold to 1000 Kilobits/sec and Critical threshold to 2000 Kilobits/sec) -R, --rawperfdata Use raw values for Performance Data thresholds (Can be used in combination with -r i.e. -r -R )

You must be logged in to submit a review.

Your review has been submitted and is pending approval.

Your recommendation has been sent.

Project Overview Project Files Project Photos Project Notes Reviews