Check APC UPS

This script uses only snmp, please note you need PERL installed with modules: - perl-Net-SNMP - perl-Switch UPS uses SNMPv1 that you can configure from the web interface. This script provides perfomance data and range monitoring for a wide series of data, it comes with a built-in help ------------------------------------------------------------ Usage: -H Address of hostname of UPS (required) -C SNMP community string (required) -l Command (optional, see command list) -p SNMP port (optional, defaults to port 161) -t Connection timeout (optional, default 10s) -w Warning threshold (optional, see commands) -c Critical threshold (optional, see commands) -u Script / connection errors will return unknown rather than critical Commands (supplied with -l argument): id The UPS model name (e.g. 'APC Smart-UPS 600') and interlan info about Firmware, CPU S/N and manufacturing date bat_status The status of the UPS batteries bat_capacity The remaining battery capacity expressed in percent of full capacity bat_temp The current internal UPS temperature expressed in Celsius bat_run_remaining The UPS battery run time remaining before battery exhaustion ** NB: thresholds must be expressed in minutes ** bat_replace Indicates whether the UPS batteries need replacing bat_num_batt The number of external battery packs connected to the UPS bat_num_bad_batt The number of external battery packs connected to the UPS that are defective bat_act_volt The actual battery bus voltage in Volts ** NB: thresholds must be expressed in range as nearest values. ex: normal=220, warning=215:225, critical=210:230 ** ** Additionally, the checks will look for Nominal Voltage (as returned by the UPS), and exit as CRITICAL if Actual Voltage is LOWER or Equal ** power_modules The status of power modules in_phase The current AC input phase in_volt The current utility line voltage in VAC ** NB: thresholds must be expressed in range as nearest values. ex: normal=220, warning=215:225, critical=210:230 ** in_freq The current input frequency to the UPS system in Hz ** NB: thresholds must be expressed in range as nearest values. ex: normal=50, warning=45:55, critical=40:60 ** out_status The current state of the UPS out_phase The current output phase out_volt The output voltage of the UPS system in VAC ** NB: thresholds must be expressed in range as nearest values. ex: normal=220, warning=215:225, critical=210:230 ** out_freq The current output frequency of the UPS system in Hz ** NB: thresholds must be expressed in range as nearest values. ex: normal=50, warning=45:55, critical=40:60 ** out_load The current UPS load expressed in percent of rated capacity out_current The current in amperes drawn by the load on the UPS comm_status The status of agent's communication with UPS.

You must be logged in to submit a review.

Your review has been submitted and is pending approval.

Your recommendation has been sent.

Project Overview Project Files Project Photos Project Notes Reviews